[Karin P.]

I wanted to seal a tile with an alcohol ink painting. Apparently I did not pay enough attention and ended up with lots of tiny bubbles and one small spot was left without resin. I tried pouring just a little on the empty spot and ended up with a bulge.
I’m wondering if pouring a thin layer over all of it and using a heat gun would at least give me a smooth surface.
Thanks in advance for your advice,
Karin P.

[Katherine Swift]

Pouring to fill in one spot never works out well unfortunately. Recoat the entire tile with a new layer of resin. Use painters tape to create a dam around the outside if that would help you. Once the resin has cured, you can peel away the tape.

[Author]

Posts