[Jeannette Odhner]

Hi.
I have a slight obsession with doing 5D paintings when I watch tv. Completely mindless and no creativity on my part. So I started doing smaller round ones and decided to put them in large resin plates. My first was ok. But, I got perfectly circular holes in the finished product. I put a resin layer over the beads first. Let it cure. Poured a thin layer of resin in the plate mold and then put my cured resin piece down. I assume the holes are from air bubbles? Should I have also put resin on the cured resin before putting it on the mold?

[Katherine Swift]

Hi Jeanette,

I’m not sure what’s going on here. Can you link to a picture that shows what’s going on?

[Author]

Posts