[F Lowry]

Hello – I used Environmental Technology 33900 Mold Release and Conditioner on my silicone molds, let it dry, then proceeded to pour epoxy resin. Items are releasing fine, but I have some ‘water’ spots on the surface of the finished pieces. Is there a trick for removing these water spots off of the cure pieces? I tried rubbing a little with microfiber and it did not work. BTW, I have since seen your video on how to properly use release spray and will use that technique next time. But, this time, I need some help! I poured a big batch and almost everything has spots on it! Thanks for your help!

[Katherine Swift]

Hi Lowry,

Try removing the spots with rubbing alcohol.

[Author]

Posts