- This topic has 4 replies, 2 voices, and was last updated 7 years, 1 month ago by
.
-
Posts
-
-
This question comes from Sylvia:
I have a question about an inconsistent batch of resin, where some items cured and some didn’t. I also am wondering about thin coats of resin to fix the ones that didn’t cure. I’ve read that thin layers don’t cure as well as thick ones, but this is also the remedy for a tacky surface. It seems contradictory, but I guess I’m missing something here. Thanks!
-
Hi Sylvia,
It has been my experience that 75% of the time when resin cures sticky or didn’t cure all the way, it is either from inaccurate measuring or incomplete mixing. We have a few other suggestions on why your resin may be sticky in this article: https://resinobsession.com/resin-frequently-asked-questions/resin-troubleshooting-tips
If the surface of the resin is sticky (not gooey), then yes, you can apply another layer of resin to fix it.
You are also correct in that thinner layers of resin may have a harder time curing. That’s because the heat produced from the resin and hardener mixing together is sometimes not enough to cause it to cure when it is spread in a thin layer. Warm your resin ahead of time (here’s an article showing how to do that: https://resinobsession.com/resin-resin-resin/resin-casting-in-cold-weather) and make sure your room is in the low 70’s F to help with the curing.
-
Thanks, Katherine! It was a strange batch. They ranged from perfectly fine to tacky to gooey. I had made sure the room was warm and thought I had stirred thoroughly (I had read your tips!) Next time I’ll also warm the bottles.
-
-
This may be caused by the wrong type of silicon, bad or outdated catalyst. With the little bit of info provided, it is hard to determine. We’re you working with a polyester, epoxy, polyurethanes? Etc. Mold type, release agents, etc.
-
- The topic ‘Inconsistent curing resin’ is closed to new replies.