- This topic has 1 reply, 1 voice, and was last updated 2 years, 11 months ago by
.
Viewing 1 reply thread
-
Posts
-
-
Do you sand the entire piece (top, bottom and sides) to remove dust from the top of a cured molded piece? Then after sanding, do you put the piece back in the mold for a new clear top coat of resin? Thank you!
-
Hi Janet,
You only need to sand the side that has the dust. Then, apply a layer of a coating resin to get it glossy. You don’t need to put it back in the mold.
This is the resin to use: https://shop.resinobsession.com/products/resin-obsession-crystal-doming-epoxy-resin-jewelry-grade
-
Viewing 1 reply thread
- The topic ‘Removing dust in cured resin’ is closed to new replies.