bubbles on tile

Tagged: 

Viewing 1 reply thread
  • Author
    Posts
    • March 12, 2018 at 7:38 pm #12693
      Karin P.
      Guest

      I wanted to seal a tile with an alcohol ink painting. Apparently I did not pay enough attention and ended up with lots of tiny bubbles and one small spot was left without resin. I tried pouring just a little on the empty spot and ended up with a bulge.
      I’m wondering if pouring a thin layer over all of it and using a heat gun would at least give me a smooth surface.
      Thanks in advance for your advice,
      Karin P.

    • March 12, 2018 at 11:25 pm #12694
      Katherine Swift
      Keymaster

      Pouring to fill in one spot never works out well unfortunately. Recoat the entire tile with a new layer of resin. Use painters tape to create a dam around the outside if that would help you. Once the resin has cured, you can peel away the tape.

  • Author
    Posts
Viewing 1 reply thread
  • The topic ‘bubbles on tile’ is closed to new replies.