Water on top of curing resin

Viewing 1 reply thread
  • Author
    Posts
    • February 26, 2019 at 4:55 am #32986
      Madison
      Guest

      Hi,
      So i just poured some resin into a mold and then went to sent my molds in a warm water bath to help rid the resin of any lingering air bubbles. I filled he water a little to high in the bin so when i placed my mold in it water got on the surface of my resin (the actual piece is surrounded by the mold the pouring hole, an area i usually sand off in the end, is what got water on it) will this mess up my piece?

      Thank you for any advice or help!

    • February 26, 2019 at 11:40 am #33031
      Katherine Swift
      Keymaster

      Yes, unfortunately, it’s going to mess up your casting. Resin hates water. Your piece is likely to cure sticky, if it cures at all.

  • Author
    Posts
Viewing 1 reply thread
  • The topic ‘Water on top of curing resin’ is closed to new replies.