- This topic has 1 reply, 1 voice, and was last updated 5 years, 6 months ago by
.
-
Posts
-
-
This question comes from Anne:
I want to use the doming method on both sides of a leaf not using a mould, to make a pendant.
So I put the leaf on a doming tray and did one side and it looked awesome. Then I flipped it when it was dry to do the backside but it seems that the sides don’t adhere to each other. The sides actually split apart. So I tried letting some resin drip over the edge of the backside for a seal but then the resin was sticks to the leaf on the other side and I can’t get it off. Any suggestions for two sided doming that would seal the edges together somehow?
-
Hi Anne,
To get an even edge on your leaves, try laminating them, then applying the resin. Use the same technique as the butterfly wings in this article https://resinobsession.com/resin-tutorials/casting-butterfly-wings-resin/
Dome one side, allow to cure, the dome the other.
-
- The topic ‘How to dome resin on a leaf’ is closed to new replies.