- This topic has 3 replies, 1 voice, and was last updated 4 years, 7 months ago by
.
-
Posts
-
-
Hi
I am trying to cast bullets in resin but a thin layer of air is around the Buillet when the resin is set, do I need to do something to the bullet first before putting in the mould, and what is the best resin to use for a clear cast in two hits up to 25mm deep
Thank you and best regards
Paul -
Hi Paul,
It sounds like you are experiencing ‘silvering’. This forum post explains more: https://resinobsession.com/forums/reply/524/
How much resin volume are you casting at once? That will best help me with a specific resin recommendation.
-
Hi Katherine
I am pouring between 10mm and 20mm at a time-
Hi Paul,
If you are mixing three ounces of resin or less at once, then the Resin Obsession super clear resin is my choice:
https://shop.resinobsession.com/collections/resin/resin-obsession-super-clear-resinIf you are mixing three ounces of resin or more at once, they go with the Resin Obsession deep pour resin:
https://shop.resinobsession.com/collections/resin/resin-obsession-deep-pour-resin
-
-
- The topic ‘Air bubbles around bullet’ is closed to new replies.