Resin diorama water effect

Viewing 1 reply thread
  • Author
    Posts
    • June 2, 2020 at 12:54 am #84601
      John Haigh
      Guest

      Hello – I built a round underwater diorama scene depicting the Creature from the Black Lagoon and I’d like to pour resin into it to create an underwater effect. I would estimate that the volume is under a gallon (I bought a gallon epoxy resin kit from a company called “America’s Best”). I was going to pour a sand/resin base first and then the water effect after the base cures. Someone told me that there could be an issue with heat using that much resin. I’ve also read that resin should be poured in layers. Any issues I should be concerned about

    • June 2, 2020 at 9:37 am #84605
      Katherine Swift
      Keymaster

      Hi John,

      This resin may or may not work for your project. It’s hard to say without knowing more details.

      I recently did a video class on how to choose a resin that would be helpful to you in knowing the questions you need to ask about this resin to see if it will work for your diorama or not. You can watch the replay on this page: https://resinobsession.com/resin-frequently-asked-questions/resin-buying-guide/

      • June 2, 2020 at 7:00 pm #84612
        John Haigh
        Guest

        Hi Katherine,
        Thanks for replying. I watched the first half of your video (will get to the 2nd half after work today). A lot of very helpful advice! The resin I bought says “Premium Epoxy Resin.” It says it’s a jewelry, craft, coating & casting resin. The round container I’m using is about 7 inches across and the pour would be about 7 inches deep. You mentioned in your video to not pour more than a 2 inch deep layer. Is that because of the heat that would be generated? I want to be sure and avoid lines between the layers. About how long should I wait between pours to make sure they don’t form lines?

        • June 3, 2020 at 2:50 pm #84614
          Katherine Swift
          Keymaster

          Hi John,

          We recommend not pouring the Resin Obsession deep pour epoxy resin more than two inches at once because of the heat produced. It can cause your resin to heat up too quickly and crack. I don’t know about the resin you mention.

          To minimize the lines between layers, pour the next layer once the previous layer has started to gel.

  • Author
    Posts
Viewing 1 reply thread
  • The topic ‘Resin diorama water effect’ is closed to new replies.