Uneven resin tray This topic has 1 reply, 1 voice, and was last updated 3 years, 9 months ago by Katherine Swift. Viewing 1 reply thread Author Posts March 9, 2021 at 9:43 pm #92077 ShelleyGuest Hi I have made a beautiful resin tray with handles. Sadly when I took it out of the mould it is uneven 😅 it does not sit flush in a surface and one edge is slightly bent upwards. Any way I can salvage this pice by somehow coating again to make it even? Thanks March 10, 2021 at 12:55 pm #92086 Katherine SwiftKeymaster Hi Shelley, I’m sorry this happened to you. Here’s how I would fix it. 1. Flip it over so the bottom surface is facing up. 2. Apply a tape dam to the edge of the tray. 3. Make sure the surface is level. 4. Apply a coat of artwork resin. This is the one I would use: https://shop.resinobsession.com/collections/resin/products/resin-obsession-artwork-epoxy-resin Author Posts Viewing 1 reply thread The topic ‘Uneven resin tray’ is closed to new replies.